Propel air 160 gauge instructions

• Operate compressor in an open area at least 12" (30.5 cm) away from any wall or obstruction that would restrict the flow of fresh air to the ventilation openings. • Operate compressor in a clean, dry well ventilated area. Do not operate unit indoors or in any confined area. Before using this equipment, read the manual and follow all safety rules and operating instructions. SAVE THESE INSTRUCTIONS. Form No. 769-19555A (December 11, 2018) INSTRUCTION MANUAL | MANUAL DE INSTRUCTIONES FRONT WHEEL DRIVE MOWER Model Nos. CMXGMAM1125501 CMXGMAM2703841 CMXGMAM1125502 CMXGMAM1125503 CMXGMAM1125504 CMXGMAM2703842 CMXGMAM7435274 Air Tank Pressure Gauge E. Regulated Pressure Gauge F. Pressure Regulator G. Air Outlet H. Unloader Valve Honda 160 cc Internal Combustion 4-stroke High RPM 2000-3600 Idle RPM 1250-1600 Specifications can propel dirt, chips, loose particles and small objects at high speed, resulting in Fresh-air cab fi lter is quickly serviced from outside the cab where it's more likely to get done. 2. Easy-to-navigate LCD color monitor tracks up to 14 maintenance intervals and lets an operator check any of 32 machine operating parameters at the touch of a button. 5. Wide-fi n spacing lets trash easily pass through cores to resist plugging. Carefully follow all instructions. 2. Be sure cylinder valves are fully opened. 5. Replace empty cylinders as soon as practical after the manifold has depleted, and the full reserve cylinder valve has been opened, placing it in service. Cylinder Replacement and Handling 1. Shut off all cylinder valves and header valves on depleted cylinders. 2. range is -40 to +160 degrees F. 3. AIR CYLINDER VALVES are located on the Air Cylinder. An internal over pressure relief valve opens and vents the Air Cylinder if the internal pressure reaches 4000 psi. An air pressure indicating gauge is mounted on the main control panel. 4. FOAM CHARGE VALVE fills the discharge hose with pressurized foam when SAVE THESE INSTRUCTIONS DANGER: RISK OF EXPLOSION OR FIRE WHAT CAN HAPPEN HOW TO PREVENT IT • Spilled gasoline and it's vapors can become ignited from cigarette sparks, elec- trical arcing, exhaust gases and hot engine compo- nents such as the muffler. • Shutf of engine and allow it to cool before adding fuel to the tank. system uses compressed air to propel fire fighting foam. Thousands of tight radius set to an operational pressure of 160-165 psi at the factory. The regulator's operational An internal over pressure relief valve opens and vents the Air Cylinder if the internal pressure reaches 4000 psi. An air pressure indicating gauge is mounted on This one-of-a-kind water rocket launcher kit uses pressurized water and air to propel a soda bottle up to 350 feet with gentle recovery! Squeeze the brake lever to release the rocket from a safe distance of 10 ft. and out of the splash zone. 160 PSI air pressure gauge, 125 PSI safety valve and complete instructions. Features: Screw-on SLOWLY turn on the air system and increase the input pressure to 150-160 psi. For accurate adjustment, fire the marker, and readjust if necessary. 5. Attach the barrel and a loader. Put paintballs in loader. 6. Change the Impulse to " Eye-On Mode IMPORTANT : In Eye-On Mode, the first shot will always fire with or without a ball in the chamber. 7. Approx. Cut-out 160 PSI SCFM @ 40 psig *6.3 SCFM @ 90 psig *4.9 * Tested per ISO 1217 Over inflation of tires could result in _ Use a tire pressure g